適用范圍：◆ Recommended substrate: Harden PC, harden PMMA, the surface of UV coating, electroplating layer, stainless steel, stone, marble, glass, etc.
◆ Recommended for: Windows screens, the phone keypad, the phone shell, the metal products, the stone crafts, the glass products, etc.
◇ 適用基材：加硬PC，加硬PMMA，UV漆面，電鍍面，不銹鋼，石頭，大理石，玻璃等
◇ 推*用途：視窗屏，手機按鍵，手機殼，金屬制品，石頭工藝品，玻璃制品等
詳細描述：ALABINE CA series inks, which based on special mixed resins, are of multi-functional features and use widely. These series inks with good adhesion are scratch resistant, alcohol resistant, sterilization resistant and anti-static ALABINE CA系列油墨采用了特種混合樹脂，具有多功能特點，應用范圍廣。該產品附著力好，耐磨抗刮，耐酒精，耐蒸煮，防靜電。 Prepare: To clean the surface with ALATIVE SC5 treater （ALATIVE SC23 treater for the metal products and the glass products） and make sure non-dust, non-grease. To dilute the mixture with 3-20% ALATIVE SR6 thinner and then is ready（In order to regulate the drying rate of ink ,please make use of ALATIVE RR6 dry retarder or ALATIVE SF3 dry accelerant）. Mix the ink with the ALATIVE SA5 (10-15%, to total) activator completely (15-25% ALATIVE SA6 activator for the metal products and the glass products). Mesh count: 70T to 180T Drying: Air dry in 12-18 hours, or forced dry at 80 OC in about 40 minutes. Cleaning: To remove the stain and bad print with ALATIVE SC6 remover, and to clear the screen plate with ALATIVE CC6 cleaner. 印前：用ALATIVE SC5清洗印件表面（金屬制品和玻璃制品，則用ALATIVE SC23），確定無塵、無油脂；用3-20%的ALATIVE SR8將產品稀釋至需要稠度，即可印刷（調節油墨干燥速度，可以配合適量的ALATIVE RR6或ALATIVE SF3）；添加10-15%（對總量）ALATIVE SA5活化劑（金屬制品和玻璃制品時，則用15-25%的ALATIVE SA6活化劑），與油墨充分混合，即可。 網紗：70T至180T 干燥：自然風干，12至18小時；或70OC烘干，約45分鐘。 清洗：用ALATIVE SC6清除污點和不良印刷；用ALATIVE CC6清洗網板。
點擊圖片查看原圖
